Digi m10 Flight Test 1

This test will fly the digi on a latex balloon via SpacePort Indiana Nov 5. Goal will be to log some sort of satellite reception quality data. This may just be the Satellite Available line status, as there's not much space on an arduino for data logging.

Power: 9-18v (Maybe 6xAA battery pack?)

Antenna: Homemade Dipole

Connection Pins
Digi Signal Rail Arduino
7 - RX (TTL) D2
8 - TX (TTL) D3
9 - SA (Satellite Available) D4
10 - DA (Data Available) D5


  • Prepping for flight Antenna on roof
hardware/radio/digim10/flighttest1.txt · Last modified: 2018/07/29 17:58 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki